Specifications:

Walls
CONCRETE PANELS - Machine vibrated and reinforced with a purpose made steel mat to give maximum strength.

All panel joints are sealed with a natural colour mastic. Exterior finish in either hard wearing and maintenance free. Standard multi coloured Canterbury Spa or as an alternative a Limestone finish.

White spa finish available at an extra cost. Plain cement panels can be supplied, where stone or brick cladding is to be fixed by others.

Roofs:
FLAT ROOF MODELS - Corrugated cement fibre roof sheets fixed to purpose made steel trusses.

Roof height at front 7'4", at rear 6'8"

The roofs on double width garages are centrally supported by a steel stanchion or a central dividing wall which increases the overall width of the garage by 3".

GUTTER AND FALLPIPE FITTED AS STANDARD.

APEX ROOF MODELS - Corrugated cement fibre roof sheets fixed to purpose made steel trusses and treated timber purlins.

TILED APEX ROOF GARAGES - Can be supplied ready for tiling by others. Roof pitch 17½% or pitch 25% to suit customers needs.

Single garages - Height to eaves 6'10" Ridge 8'10"

Double garages - Height to eaves 6'10" Ridge 9'0"

Centre walls not available on Apex double garages. Gutter and fallpipe can be fitted at extra cost.

Windows:
One fixed window is standard fitting on all single garages, and 2 fixed windows on double garages.

All windows are 4' wide x 2'6" deep, rear wall window sizes may vary due to the width of the garage and customers individual needs.

Doors:
The choice is yours without extra cost. For a table of door widths relative to garage sizes, click here.

Either Traditional Timber doors (with or without windows) Morticed and tenoned, framed and braced 2" nominal timber cladded with P.T.G boards complete with lock and keys.

Or a superb galvanised steel up and over door in a primer coat finish. These doors have an advanced design with overhead tensioned springs for correct balance and complete safety and multi point locking.

All doors are centrally fitted unless otherwise requested. All up and over doors come in a colour coat finish, suitable for painting.

All timber is treated with a coloured stain/preservative. Except on the Georgian where the woodwork is painted with a white undercoat.

Concrete bases:
All concrete bases are to be erected on a permanent concrete base. We recommend that this should of been laid about a week prior to erection of the garage. It is absolutely necessary for the base to be flat and level, determined by the use of a large spirit level.

A good concrete mix is 1 part cement, 2 parts sand, 4 parts gravel; your local readymix firm will tell you the amount required if you give them the size of your intended base.

Special extra height buildings:
These can be supplied in most garage sizes. 8' panels are used and extra height up to 10' maximum can be obtained with a timber cladding, or plastic coated galvanized sheeting, and timber hinged doors or steel up and over doors (max height 8') can be fitted. The front can be made with an opening to accommodate roller shutter doors to be fitted by others.

Click Here To Veiw www.shedshop.freeola.com